Load Lock® Dinghy / RIB Lift System
Simple lift system for boat tenders that works with most mast halyards, davits, & boat lifts
The Load Lock® Dinghy Lift system is designed for all Rigid Inflatable Boats (RIBs) or dinghies up to 14 feet in length and weighing less than 350 pounds. To ensure maximum safety, this lift should not be used when outboard motors are attached to a tender. This lift should not be used when people are onboard the boat that is being raised or lowered.
Simple to use:
1.) Attach three straps to dinghy using Load Lock® mechanism - one to the bow of dinghy and two to the stern - If attaching to aft pontoons, make sure to pass the strap through a suitable holding object such as a handle.
2.) Adjust the straps and connect the three straps at their Stainless Steel O-Rings with the Stainless Steel Spring Clip.
3.) Connect Spring Clip to suitable lifting device (e.g., mast halyard, davits, or boat lift).
4.) Raise or lower boat as necessary.
Contents of Dinghy Lift System:
(Qty. 3) 15' x 1" Black Nylon Straps, each with Stainless Steel Ring and Load Lock®
(Qty. 1) Stainless Steel Spring Snap to connect the three strap rings to a lifting device
(Qty. 1) Nylon mesh drawstring bag for storage
Load Lock® Dinghy / RIB / Tender Lift System (Qty. 1) Dinghy / RIB Lift, Item # 801 (3B-801DL), Black, with mesh bag $54.95
Will Not Rust or Scratch Secured Tenders
100% Stainless Steel Hardware Machine-washable
Following are trademarks of
DRD Corporation:
Load Lock FASTener®,
the Load Lock® logo,
Plugamid®,
the Plugamid® logo,
Back Seat Driver®,
Strap Sack™,
Handy-Hooker™,
Roof Rack In a Sack™
The strongest plastic fastener on earth!
